15 Gallon Red Drag Racing Fuel Cell Gas Tank+Level Sender Diesel

15 Gallon RED Coated Aluminum RACING/DRIFTING FUEL CELL GAS TANK+LEVEL SENDER

100% Brand new&Fast shippping

Application

Universal fit and design for developing car powerful!(Check the size before you order!

Dual -10 outlets

Dual -10 vent outlets (top Of cell)

0-90 Ohm fuel sender

Integrated sump

Quick release fuel cap

Fuel tank made with high grade aluminum for extra protection

Professional Installation is Highly Recommended (No Instruction Included)

100% quality assurance tested,more responsive, less expensive, easier to install.

If you have any questions and needs, please feel free to contact our customer service.

INSTALLATION INSTRUCTIONS

Fuel Cells

IMPORTANT! The following steps are precautionary actions taken to avoid any failures,

damages and/or injuries to the vehicle and/or person(s) in area. These are highly

recommended steps that will help ensure a safe working standard.

1. Do not use a hydraulic jack as means of supporting your vehicle while working on

it. Instead, use jack stands to rest the weight of the vehicle on when working

underneath of it.

2. Always have vehicle and jack stands on a solid, level surface to prevent

slipping/shifting and possible injury and/or damages. DO NOT USE JACK AND

OR JACK STANDS ON GRAVEL!

3. Remove the ground cable from the negative battery terminal, to prevent any

accidental injuries or damages from electrical contact.

4. Never run vehicle in enclosed space for extended periods of time due to toxic fumes

coming from exhaust. Always make certain work space is well ventilated.

5. Eye and ear protection is recommended when using power tools on your vehicle.

Made from aluminum alloy,

aluminum fuel cells offer superior

strength in a lightweight package. They are

available in natural satin, as well as red, blue, and

black powder coated finishes. If you have any

questions or concerns, please contact us

Gasoline vapors are highly flammable. It burns and can cause bad injuries. Do NOT

smoke near gasoline or when fueling. Keep sparks and flames away from gasoline.

Open the fuel cell lid slowly and wait for the pressure to release before refueling. If

you need a new fuel cell lid, please contact us for the correct fitting one. We have

included a vent bung located on the top of the cell. It is required that a hose be ran

below the bottom of the cell and outside of the vehicle. Fuel cells should be kept

well vented to insure they do not build pressure.

1: Mount the fuel cell according to the requirements of your racing classification or

sanctioning body.

2: Fuel cells should always have a good solid floor support under the cell for the

weight of the fuel. You must have support straps all around the cell. The top,

bottom, and both sides must have the proper support. Strap kits are available for

all fuel cells. Please contact us for purchasing information.

3: Removal of any sharp metal edges from the area around the fuel cell is

recommended to prevent penetration of the fuel cell upon impact.

Note

All Fuel cells must be vented properly by locating a hose

from the bung located on the top of the cell to below the bottom of the cell

and outside the vehicle.

Gauge sending units are available in the following ohm ranges

0 ohms - Empty 90 Ohms – Full GM Gauges

70 Ohms – Empty 10 Ohms - Full Ford / Mopar Gauges

10 Ohms – Empty 180 Ohms – Full VDO Gauges

Sending units will work with most factory style or aftermarket style gauges that

have the above ranges. Please check your original sending unit ohm range or

replacement gauge instructions to insure correct resistance prior to installation of

the sending unit. On Most senders, the center post wires directly to the gauge and

you must ground the spade terminal to your frame. Always make sure that your

fuel cell is grounded and vented correctly.